1 software. In a typical synthesis procedure, a previously dried 100 mL Schlenk flask equipped with a magnetic stirring bar was charged with (PCL)2-Br2 (4.0 g, 0.8 mmol) and CuBr2 (0.0143 g, 0.064 mmol). The real-time FTIR probe was introduced into the flask, and the flask

was then evacuated and flushed with argon thrice. Anhydrous toluene (18 mL), DEA (4.8 g), and ligand HMTETA (0.164 mL, Fer-1 research buy 0.64 mmol) were injected into the flask using degassed syringes in order. The mixture was stirred for 10 min, and a required amount of Sn(Oct)2 (0.259 g, 0.64 mmol) solution in toluene (2 mL) was added into the flask by syringe. The flask was placed in a preheated oil bath maintained at 70°C, and the FTIR spectra were collected at the time. After 5 h, the absorbance of 938 cm−1 was kept almost constant and the second

monomer PEGMA (M n = 475, 6.4 g) was then Idasanutlin cell line introduced by syringe to continue the polymerization for another 20 h. Then, the flask was removed from the oil bath and cooled to room temperature. THF (50 mL) was added into the flask, and the mixture was then passed through a neutral alumina column to remove the catalyst. After removing the catalyst, the product was recovered by being precipitated into tenfold excess of n-hexane, filtered, and finally dried under vacuum for 24 h. CMC measurement The critical micelle concentration (CMC) values of (PCL)2(PDEA-b-PPEGMA)2 were determined by the fluorescence probe technique using pyrene as a fluorescence probe. Pyrene dissolved in acetone was added into deionized water (pH 7.4) to make a concentration of 12 × 10−7 M following by removed acetone 2 h through evaporation. The final concentration of pyrene was adjusted to 6 × 10−7 M. The (PCL)2-(PDEA-b-PPEGMA)2 (5 mg) was first dissolved into 50 mL deionized water and then diluted STK38 to a series of concentrations from 0.0001 to 0.1 mg/mL with deionized water. Then, 10 mL of polymer solutions at different concentrations were added to the pyrene-filmed vials, respectively, and the combined solutions were equilibrated at room temperature in the dark for 24 h before measurement. The fluorescence excitation spectra of polymer/pyrene

solutions were measured and used for determining the CMC values. Preparation of empty and DOX-loaded micelles The empty and DOX-loaded (PCL)2(PDEA-b-PPEGMA)2 self-assembled micelles were prepared according to the diafiltration method. Typically, (PCL)2(PDEA-b-PPEGMA)2 (40 mg) was dissolved in 20 mL of DMSO (40 mL for empty micelles) at room temperature 25°C, followed by adding a predetermined amount of DOX∙HCl (10 mg) and double molar amount of TEA in another 20 mL of DMSO and then stirring for 4 h. Then, the mixture solution was transferred to dialysis bag (MWCO = 3.5 kDa) and dialyzed against deionized water for 24 h to remove the organic solvents and free DOX. The deionized water was changed every 4 h for the first 8 h and then replaced every 6 h.