0 mg/mL) followed by stirring at 60°C for 12 h During the alkyla

0 mg/mL) followed by stirring at 60°C for 12 h. During the alkylamine functionalization, the color of the GO solution gradually changed from yellow to black. This change was accompanied by an aggregation of graphene particles due to the hydrophobicity of the alkylamine-functionalized GO, indicating the simultaneous functionalization and slight reduction of GO [14, 19]. The suspensions were filtered and washed three times with methanol. The obtained products were denoted Stattic nmr as FGO-OA, FGO-DDA, and FGO-HDA, respectively.

For solution blending of the FGOs and PS, we selected chloroform (OCI Chemical, Seoul, Korea), which is an effective media for both FGOs and PS. Based on the amount of PS (M w approximately 192,000 g mol−1, Sigma Aldrich, St. Louis, MO, USA), the FGO loadings relative to PS were fixed at 0.5, 1.0, 2.0,

3.0, 5.0, and 10.0 wt.%. Solution blending was easily performed by adding 5 g of PS into the FGO in chloroform. The resulting FGO/PS solution was stirred for 2 h followed by sonication for 30 min. After that, the FGO/PS suspension was coaggregated by pouring the solution into 1.5 L of methanol (SK Chemicals, Gyeonggi-do, Korea) under vigorous stirring for 1 h. The products were filtered and washed three times with methanol and dried at 60°C for 12 h. Characterizations The compositions of the FGO/PSs were analyzed using an elemental analyzer (EA; Flash 2000, Vactosertib Thermo Scientific, Hudson, NH, USA). Fourier transform infrared (FT-IR) spectra were analyzed using an FT-IR spectrometer (Nicolet 380, Thermo Scientific, Madison, WI, USA). The morphologies of the freshly fractured surface of the neat PS and FGO/PS composites film were observed by scanning electron microscopy (SEM; JSM-6500FE, JEOL, Tokyo, Japan). A small amount of the FGO/PS nanocomposites was dispersed in ethanol in order to obtain meticulous field emission transmission electron microscope (FETEM; JEM-2100 F, JEOL,

Tokyo, Japan) images. Thermogravimetric analysis (TGA) was performed under a nitrogen atmosphere at a heating rate of 10°C/min (Q50, TA MDV3100 ic50 Instruments, New Castle, DE, USA). The dynamic Idelalisib mw mechanical properties of the FGO/PS composites were measured using a dynamic mechanical analyzer (DMA-Q800, TA Instruments, New Castle, DE, USA) in the single cantilever deformation mode at a frequency of 1 Hz from 0°C to 180°C at a heating rate of 3°C/min. Results and discussion As shown in Figure 1, FT-IR was used to verify the formation of covalent bonds between GO and the alkylamines. Typical peaks for GO were obtained, including C-O-C (1,110 to 1,047 cm−1), C = C (1,585 cm−1), C = O (1,720 cm−1), and -OH (3,376 cm−1). In the case of FGO-DDA, the intensity of the C-O-C peak decreased significantly after functionalization, and two new prominent peaks appeared at 2,850 cm−1 and 2,920 cm−1, corresponding to the stretching and vibration of -CH2 groups, respectively, that originated from the alkylamine [21].

Comments are closed.