From the time of its discovery, it has been known that the cloned daaC fragment probe (in plasmid pSLM862) can only identify a subset of DAEC and that some DAEC strains have other adhesins, of which many, but not all, are from the Afa/Dr family [2]. However, the daaC probe is the one that has been employed most frequently in epidemiological research to date 8-13. In this paper, we report

that the daaC cross-hybridizes with a specific subset of EAEC strains. We sought to identify the molecular basis for this cross-hybridization #FRAX597 price randurls[1|1|,|CHEM1|]# and to devise an alternate, cost-effective protocol for identifying DAEC. Methods Strains Cross reaction of the daaC probe with EAEC was identified in the course of screening 509 test E. coli strains, which were isolated from 130 travellers with diarrhoea (up to four isolates were obtained from each specimen), who returned to the UK in 2002-2003, from a total of 33 different countries [14]. We additionally employed 26 well-characterized archival EAEC strains and seven DAEC strains for control purposes. E. coli K-12 TOP-10 (Invitrogen) was used to maintain plasmids and non-pathogenic strains DH5α and MG1655 were used as non-adherent controls. Routine molecular biology procedures Standard molecular biology procedures

were employed [15]. DNA amplification was performed using 1 unit recombinant Taq Anlotinib chemical structure polymerase enzyme, 2 mM magnesium chloride, PCR buffer (Invitrogen, Carlsbad, CA) and 1 μM oligonucleotide primer in each reaction. All PCR

amplifications began with a two-minute hot start at 94°C followed by 30 cycles of denaturing at 94°C for 30s, annealing for 30s at 5°C below primer annealing temperature and extending at 72°C for 1 minute for every Kb of DNA being amplified. PCR reactions were Ureohydrolase templated with boiled bacterial colonies or genomic DNA. High fidelity PCR for sequencing used a similar protocol but employed Pfx polymerase and magnesium sulphate (Invitrogen). The annealing temperature was lowered by 2-3°C and extension time was doubled for Pfx high-fidelity PCR. Purified PCR-amplified fragments were incubated with Taq polymerase and dNTPs at 72°C for 20 minutes and then cloned into the pGEM-T vector (Promega) according to manufacturer’s instructions. Plasmids were transformed into chemically competent E. coli K-12 TOP10 cells (Invitrogen). Colony hybridization Colony lifts of test and control strains cultured in Brain Heart Infusion medium (Oxoid, England) were prepared in a 96-well format on nylon membrane (Hybond-N, Amersham Biosciences). The membranes were denatured in 0.5 M NaOH, 1.5 M NaCl, neutralized in 1.5 M NaCl, 0.5 M Tris HCl and 1 mM EDTA, dried and fixed by UV exposure. DNA probes consisted of PCR products using the primers in Table 1. The probes were labelled using the PCR DIG labelling mix (Roche), according to manufacturer’s instructions. Cloned probes were labelled using M13F and M13R universal primers.