Many reports focused on the enhanced photocatalytic performance of ZnO composites by coupling with suitable semiconductors, such as TiO2, ZnS, Bi2O3, and CuO [8–12]. The efficiency

improvement on the degradation of organic dye can be ascribed to the effective separation of photoinduced carriers. Furthermore, the separation of photoinduced electrons and holes would be greatly enhanced and more efficient especially in the inner electric field, which was formed by a p-n-type semiconductor composite, such as CuO/ZnO and Selleck AZD1152 NiO/ZnO [12, 13]. Ag2O is a p-type semiconductor with a band gap of about 1.3 eV. Recently, the modification of TiO2 and Bi2O3 was carried out using Ag2O nanoparticles decorated on the surface of photocatalysts [14–17]. Based on the heterojunction of Ag2O and TiO2, the recombination see more of photogenerated electrons and

holes was greatly inhibited by transferring for the energy band matching and the build-up inner electric field, resulting in the photocatalytic activity enhancement [15, 16]. However, to the best of our knowledge, there is no report in the literature on the photocatalytic properties of the p-n junctions of hierarchical mesoporous ZnO-Ag2O composites. In this paper, flower-like ZnO-Ag2O composites were fabricated through a chemical co-precipitation process. The as-prepared composite including Ag2O particles deposited on the petal surfaces of ZnO flowers shows high crystallization. Compared with ZnO flowers and Ag2O particles, the photocatalyst ZnO-Ag2O composites with wide mole ratios exhibited enhanced photocatalytic properties that was confirmed by the degradation of methyl orange (MO) under ultraviolet irradiation. Methods Preparation of Baf-A1 in vivo flower-like ZnO All the chemicals used for the synthesis of flower-like ZnO are analytical grade reagents. Zinc nitrate solution (0.001 M) was prepared by dissolving a proper amount of Zn (NO3)2 in deionized water. The materials – 20 mL of Zn (NO3)2 solution, 20 mL of deionized water, 0.25 g of sucrose, and 1.2 g of urea – were

added into a 50-mL Teflon-lined stainless steel autoclave. The autoclave was sealed, heated at 90°C for 2 h, and finally cooled to room temperature naturally. The white precipitation (precursor) was filtered and washed several times with deionized water, find more followed by drying in air at 90°C for 2 h. The precipitations were heat-treated at 600°C in air for 2 h (heating rate of 5°C min−1) in a muffle furnace to obtain the final hierarchical ZnO flowers. Preparation of Ag2O nanoparticles Ag2O nanoparticles were synthesized from AgNO3, NaOH, and polyethylene glycol 8000 (PEG-8000) aqueous solution by the precipitation method. Firstly, 1.75 g of AgNO3 and 0.2 g of PEG-8000 were dissolved in 100 mL of deionized water. After a continuous stirring for 15 min, 0.05 M NaOH aqueous solutions were dropped into the above aqueous solution with the final pH = 14.